File Transfers
Enabling or Disabling the USB Port
Enabling or Disabling the USB Port
This feature allows configuration of the USB port with either the CLI or SNMP.
To enable/disable the USB port with the CLI:
Syntax: usb-port
no usb-port
Enables the USB port. The no form of the command disables
the USB port and any access to the device.
To display the status of the USB port:
Syntax: show usb-port
Displays the status of the USB port. It can be enabled, disabled,
or not present.
ProCurve(config)# show usb-port
USB port status: enabled
USB port power status: power on (USB device detected in port)
USB port reseat status: USB reseat not required
Figure A-17. Example of show usb-port Command Output on version K.13.59 and later
ProCurve(config)# show usb-port
USB port status: enabled
USB port power status: power on (USB device detected in port)
Figure A-18. Example of show usb-port Command Output on version K.14.XX
One of the following messages indicates the presence or absence of the USB
device:
• Not able to sense device in USB port
• USB device detected in port
• no USB device detected in port
The reseat status messages can be one of the following (K.13.XX only):
• undetermined USB reseat requirement
• USB reseat not required
• USB device reseat required for USB autorun
A-45
