A SERVICE OF

logo

Open as PDF
next previous
Chapter 2 33
Configuration management
ts_config
Figure 15 ts_config “Configure ‘scub_ip’ address” selection
ts_config checks the scub_ip address stored in NVRAM in the node.
If the scub_ip address is correct, no action is required. If the node is not
detected and scanned by ccmd, ts_config may ask you to try again
later. The ccmd detection scan process should take less than a minute.
Step 3. If prompted by ts_config (as indicated by the panel in Figure 16), click
“Yes” to correctly set the scub_ip address.
Figure 16 ts_config scub_ip address configuration confirmation
Step 4. A panel as the shown in Figure 17 appears confirming that the scub_ip
address is set. Click OK.