Specifying input parameters
Using LCDS Print Description Language 2-63
VOLUME KCODE
Specifies which double-byte character code translation table the
system will use to interpret the input data.
Syntax VOLUME KCODE = {keyword | id }
Options
Default No default
VOLUME LABEL
Specifies the type of label on the input tape.
Syntax VOLUME LABEL = label type
Options
Table 2-66. VOLUME KCODE parameter options and definitions
Option Definition
keyword Specifies a specific, standard, system defined double-byte code translation
table. The available options are:
• IBM: IBM Nihongo character set (Kanji double-byte character sets)
• IBMCHN: IBM 5550 code translation table
• JEF: Fujitsu JEF Kanji double-byte character set
• KEIS: Hitachi KEIS Kanji double-byte character set
• UCS2: ISO/IEC 10646 UCS2 character set
• USER: Refers to the single unlabeled KCODE command defined within
the JDL or JDE.
id Specifies an identifier label that was used in a previously defined KCODE
command to refer to a specific, user-defined code translation table. The id label
is required when multiple KCODE commands are contained within the JDL.
Table 2-67. VOLUME LABEL parameter options and definitions
Option Definition
label-type Specifies the type of label that the tape contains. The following types
may be specified:
• COBOL (Honeywell 2000 COBOL tape with 120-byte labels)
• NONE (the input tape is unlabeled)
• ANSI/XEROX ANSI
• SPR (Honeywell 2000 System Print Tape)
•STANDARD
• UNDEF (Input tape label is not defined)
