Specifying print format parameters
Using LCDS Print Description Language 4-35
LINE PCCTYPE
parameter: points
to note
• For the DP EPS, this parameter is treated as if the system
were an IBM 3211.
Note that there is no functional difference between IBM3211
and IBM4245 for PCC types.
• Creation of a user defined PCC table, which may be
referenced by either an identifier id or the keyword USER, is
specified using the PCC command. (Refer to “PCC
command,” later in this chapter.)
• The INITIAL parameter for any of the PCCTYPEs listed in the
previous table (except ANSI or HOST=RSX11) is TOF.
For ANSI or HOST=RSX11, the INITIAL parameter is BOF.
For USER or PCCid, the INITIAL parameter is set by the user
in the PCC command.
• The PCCTYPE=IBM3211 or IBM4245 specifies that the
printer online interface will perform checks, such as for bad or
NO OP parameters.
LINE VFU
Specifies a vertical format unit (VFU) table.
Syntax LINE VFU = {vfuid | NONE}
Options
Default NONE
Table 4-38. LINE VFU parameter options and definitions
Option Definition
vfuid vertical format unit identifier.
The command identifier of the VFU table, which must precede this reference to
it. The VFU table defines print line positions corresponding to skip to channel
parameters for the job to be processed.
NONE Indicates that any skip to channel parameter is to be replaced by a carriage
control of Print and Space 1.
