A SERVICE OF

logo

76 105SL User Guide 6/4/2004 11342L Rev. 8
Routine Maintenance
Lubrication
Lubrication
Fuse Replacement
The printer uses a metric-style fuse (5 × 20 mm IEC) rated at F5A, 250V. The end caps of the
fuse must bear the certification mark of a known international safety organization (see
Figure 6 on page 12).
Depending on the model you have, the fuse may not be user-replaceable (see Figure 44) and
may need to be replaced by a qualified service technician. Refer to the Maintenance Manual
(part number 32056L) for details.
Figure 44 • Fuse Replacement
Caution • No lubricating agents other than Zebra-supplied, silicon-only lubricants should
be used on the spindle felt clutches of this printer . Other commercially available lubricants
damage the finish and mechanical parts.
Note • Models with a user-replaceable fuse have a warning lab el nex t to th e fuse for easy
identification.