58 105SL User Guide 6/4/2004 11342L Rev. 8
Configuration
Configuration and Calibration LCD Displays
ESSID
2
ESSID
This parameter cannot be changed through the front panel.
AUTH. TYPE
2
Authentication Type
Default: OPEN
Selections: OPEN, SHARED
LEAP MODE
3
An encryption method that is available with some wireless cards. Set the LEAP user
name and password through the printer web pages.
Accepted Values: ON, OFF
Default Value: OFF
ENCRYPTION
MODE
2
Encryption Mode
Default: OFF
Selections: OFF, 40-BIT, 128-BIT
ENCRYPTION
INDEX
2
Encryption Index
Default: 1
Selections: 1, 2, 3, 4
RESET NETWORK
1
Reset Network
This option resets the wireless card and the print server when the wireless option is
running. Selecting thi s option has no effect when the wireless option is not running,
when there is no card inserted, or when the wireless password is anything other than
the default (zero).
1. Press the (+) key to select
YES
.
The LCD prompts
ARE YOU SURE?
.
• Press the (–) key to select
NO
to cancel the request.
• Press the (+) key to select
YES
and reset the network.
Table 7 • Print Server LCD Displays (Continued)
LCD Explanation
1 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
2 Appears only when the ZebraNet Wireless Print Server is installed.
3 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.
