Printer Setup
Select a Communication Interface
11342L Re v. 8 6/4/2004 105SL User Guide 15
Parallel Port Communicating using the parallel port (Figure 9) does not require special
settings. The serial settings do not affect the parallel port. Refer to Parallel Data Port
on page 64
for further information.
Figure 9 • Communicating Using a Parallel Port
Cable Requirements
Data cables must be fully shielded and fitted with metal or metallized connector shells.
Shielded cables and connectors are required to prevent radiation and reception of electrical
noise.
To minimize electrical noise pickup in the cable:
• Keep data cables as short as possible.
• Do not bundle the data cables tightly with the power cords.
• Do not tie the data cables to power wire conduits.
Printer
Computer
36-pin
male
25-pin
male
PC
25-pin
female
10 ft. (3 mm) maximum
Note • Zebra printers comply with FCC Rules and Regulations, Part 15 for Class B Equipment
using fully shielded, 6.5 ft (2 m) data cables. Use of unshielded cables may increase radiation
above the Class B limits.
Note • RS-422 and RS-485 applicati ons shoul d use twisted shie lded pa irs as recommend ed in
the TIA/EIA-485 Specification.
