54 105SL User Guide 6/4/2004 11342L Rev. 8
Configuration
Configuration and Calibration LCD Displays
HEAD CLOSE
Head Close: Press the (+) or (–) key to display other choices.
Default: Calibration
Selections: Feed, calibration, length, no motion
Determines the action of the media after the printhe ad has been opene d and then closed.
• Calibration: Recalibrates the media sensors.
• Feed: Feeds the label to the first web.
• Length: Determines the length of the label.
• No Motion: Media does not move.
BACKFEED
Backfeed Sequence: Press the (+) or (–) key to display other choices.
Default: Default (90%)
Selections:Default, after, before, 10%, 20%, 30%, 40%, 50%,
60%, 70%, 80%, off
This parameter establishes when and how much label backfeed occurs after a label is
removed or cut in Peel-O f f, Cutter, an d Appl icator modes. It has no ef fe ct in Rewind or
Tear-Of f modes. This pa rameter setting can be superseded by the ~JS in struction wh en
received as part of a label format (refer to the ZPL II Programming Guide Volume I).
Note • The difference between the value entered and 100% establishes how much
backfeed occurs before the next label is printed. For example, a value of 40 means that
40% of the backfeed takes place after the label is removed or cut. The remaining 60%
takes place before the next label is printed. A value of “before” means that all backfeed
takes place before the next label is printed.
LABEL TOP
Adjusting Label Top Position: Press the (+) key to increase the value; press the (–)
key to decrease the value. The displa yed value represents dots.
Default: +0
Range: –120 to +120 dot rows
The label top p osition adjusts the print positio n vertically on the l abel. Positive numbers
adjust the label top position further down the label (away from the printhea d), negat ive
numbers adjust the position up the label (toward the printhead).
LEFT POSITION
Adjusting Left Position
This parameter establishes how far from the left edge of a label the format begins to
print by adjusting horizontal positioning on the label. Positive numbers adjust the
printing to the left by the nu mber of dots selec ted; negative numbers shift printing to
the right.
Default: 0000
Range: –9999 to +9999
1. Press SELECT to select the parameter.
2. Press MINUS (–) to move to the next position.
3. Press PLUS (+) to change between +/– or to increase the value of the digit. The
displayed value represents do ts. For a negative value, enter the value before
changing to the minus sign.
4. Press SELECT to accept any changes and deselect the parameter.
Table 6 • Printer Parameters (Sheet 9 of 11)
Parameter Action/Explanation
