48 105SL User Guide 6/4/2004 11342L Rev. 8
Configuration
Configuration and Calibration LCD Displays
LIST FONTS
List Fonts: Press the (+) key to print a label listing all available fonts.
This selection is used to print a label listing all fonts available in the printer, including
standard printer fonts plus any option al fonts. Fonts may be stored in RAM, Flash
memory, font EPROMs, or font cards.
LIST BAR CODES
List Bar Codes: Press the (+) key to print a label listing all available bar codes.
This selection is used to print a label listing all bar codes available in the printer.
LIST IMAGES
List Images: Press the (+) key to print a label listing all available images.
This selection is used to print a label listing all images stored in the printer’s RAM,
Flash memory, optional EPROM, or optional memory car d.
LIST FORMATS
List Formats: Press the (+) key to print a label listing all available formats.
This selection is used to print a label listing all formats stored in the printer’s RAM,
Flash memory, optional EPROM, or optional memory car d.
LIST SETUP
List Setup: Press the (+) key to print a label listing the current printer configuration.
This selection is used to print a label that lists the current printer configuration
information. (Same as CANCEL Key Self Test.)
LIST NETWORK
List Network Settings: Press the (+) key to print a label that lists the current network
configuration. (Same label as shown in CANCEL Self Te st on page 86.)
This selection is used t o print a n etwork con fig uration lab el, wh ich list s the setti ngs for
the wired ZebraNet PrintServer II (PSII) and the ZebraNet Wi reless Prin t Se rv er (if
installed).
LIST ALL
List All: Press the (+) key to print a label listing all available fonts, bar codes, images,
formats, and the current printer and network configurati on s.
This selection is used to print a label that lists the five previous selections, as described.
FORMAT CARD
AB
Initialize Memory Card
Caution • Perform this operation only when it is necessary to erase all previously
stored information from the optional memory card.
1. Press SELECT to select the parameter.
If your printer is set to require a passw ord, you are p rompted to enter the passw ord.
2. Enter the password, then press SELECT.
3. Press the PLUS (+) to select B memory (PCMCIA card) or press MINUS (–) to
select the A memory (internal compact flash).
The front panel LCD asks
ARE YOU SURE?
.
4. Press MINUS (–) to select
No
and cancel the request.
The
INITIALIZE CARD
prompt is displayed.
OR
Press PLUS (+) to select
YES
and begin initialization.
FORMATTING CARD
displays. Depending on the amount of memory in the
memory card, initializa tion may take up to thre e minut es to comp let e. Wh en
formatting is complete,
FORMAT CARD
displays.
5. Press SELECT to continue with the next prompt.
Table 6 • Printer Parameters (Sheet 3 of 11)
Parameter Action/Explanation
