Filter
Top Products
Not for commercial use
– Ericsson Inc.
%DVLF2SHUDWLRQV
Turning Your Terminal On and Off
To turn your phone on, press and hold
<(6
or
12
until
your terminal beeps. The display and keypad backlight-
ing will come on for about 15 seconds. The display
should look similar to this illustration. After your termi-
nal locates the network, your service provider's name
appears in the first line of the display. If there is no ser-
vice provider, then the word Scanning... appears in
the first line of the display.
To turn your phone off, press and hold
12
until your
terminal beeps and the display goes blank.
Making Calls
Making Calls in Phone Mode
Verify that Phone Mode is selected.
Enter the phone number you want to call by press-
ing the numeric keys. The number is shown in the
display. Press
&/5
to erase a digit. Press and hold
&/5
to erase all digits.
Press
<(6
. Dialing is shown in the display while
your terminal attempts to access the system. When
your terminal accesses the system, InUse is shown
on the bottom line of the display. Call replaces
Dialing, as shown in this illustration.
If the Call Timer is enabled, the duration of the call (in
minutes and seconds) is shown in the display beside
Call.
When you finish your conversation, press
12
to end
the call.
Making Calls in Radio Mode
Verify that Radio Mode is selected.
Enter the phone number you want to call by press-
ing the numeric keys. The number is shown in the
display. Press
&/5
to erase a digit. Press and hold
&/5
to erase all digits.
Press
377
. Dialing is shown in the display while
your terminal attempts to access the system. When
Basic Operations
Call 00:01
Ditto Lornetta.book Page 24 Thursday, July 13, 2000 3:55 PM