Filter
Top Products
Not for commercial use
– Ericsson Inc.
Message Services 43
Emergency Messages
If your terminal is turned On when it receives an emer-
gency message, your terminal sounds two brief tones,
and a message similar to the one in this illustration is
shown in the display for a few seconds.
Reading Text Messages Immediately
When a message received notice is shown in the display,
you can read the message by pressing
<(6
. You can scroll
through the message one line at a time by pressing and
releasing
Ô
or
Ñ
. You can scroll up or down through
the message three lines at a time by pressing and holding
Ô
or
Ñ
.
Call-Back Messages
Some text messages you receive may be call-back mes-
sages. A call-back message contains one or more phone
numbers included by the person sending the message. If
you press
<(6
while reading a call-back message, a screen
similar to the one shown here appears. To dial the dis-
played number, press
<(6
(to place a calling card call to
the displayed number, press and hold
<(6
). If you do
not wish to call the displayed number, press
12
to
resume reading the actual message.
The up and down arrows in the top right part of the dis-
play indicate that there is more than one number in the
message. (The arrows would not appear if there were just
one number.) You can scroll through the available num-
bers by pressing
Ô
or
Ñ
. When you see the desired
number, press
<(6
to dial that number.
If you do not call back the number in the message, you
have the same options for saving and deleting the mes-
sage as you do with other text messages.
If you like, you can edit a displayed call-back number
before you make the call. In the display, the cursor
appears in reverse video, and it is initially positioned at
the far left of the second line. In editing the number, you
can:
• Enter a number at the cursor location by pressing a
number key. If a digit is already in the cursor loca-
tion, that digit, as well as all digits to its right, move
one position to the right.
• Clear the digit at the cursor location by pressing
&/5
.
• Move the cursor position without clearing anything
by pressing and holding
Ô
or
Ñ
.
Ditto Lornetta.book Page 43 Thursday, July 13, 2000 3:55 PM