Filter
Top Products
Not for commercial use
– Ericsson Inc.
Basic Operations 27
Call Receive is still shown in the display, and you
can still answer the call by pressing any key except
12
.
Unanswered Calls
Your terminal's display shows the number of calls you
have received but did not answer. You can clear the
number from the display by pressing any key or by turn-
ing the terminal Off.
If Caller Number Identification (CNI) is available from
your service provider, unanswered calls will be stored in
the ReceiveLog section of the CALL DATA Menu.
You can delete a number from the Last Dialed list by
pressing and holding
&/5
while the number is shown in
the display.
While On a Call
Using Speakerphone Submode
While on an active call in Phone Mode, the terminal will
switch to Speakerphone if the mode control knob indi-
cates red.
Using Private Submode
While on an active call in Radio Mode, the terminal will
switch to Private Submode if the mode control knob is
switched to indicate green. The terminal will operate the
same as it does in Phone Mode conversation.
Increasing or Decreasing Volume During a Call in Phone
Mode
To increase the speaker volume during a call, press the
upper key on the side of your terminal. To decrease the
speaker volume during a call, press the lower key on the
side of your terminal.
Muting the Microphone During a Call in Phone Mode
To mute the microphone during a call, press
&/5
for one
second or longer. Mic Muted is shown in the display.
Press
&/5
again (for one second or longer) to return to
your call.
Call Waiting
If you have call waiting service from your service pro-
vider, press
<(6
to answer a call when you receive the call
waiting signal. You can switch between the two calls by
pressing
<(6
. Do Not press
12
until you are ready to
end both calls.
Radio Mode Volume Control
To increase or decrease the speaker high-level volume
while you are in Radio Mode, rotate the volume control
Ditto Lornetta.book Page 27 Thursday, July 13, 2000 3:55 PM