Filter
Top Products
5-4
Setting a message report
1. Press [F5] to display the Position Reports menu.
Position Reports
1. Data Report
2. Message Report
3. Data Network ID
Figure 5-4 Position reports menu
2. Press [2] to display the Message Report.
3. Press [1], [2], [3] or [4] to set addressee desired.
You can set four addressees.
M
essage
R
eport
OFF
TELEX
Regular Interval
00:10
1 (---: No Limit)
--:--
--:--
--:--
--:--
NAV+SEA INF
PIN Code
INT *********
Message Report Programming
Status
Station Name
Destination Type
Country/Ocean Code
Station ID
Modem Type
Subject
LES ID
Activation
Interval Time
Report Times
Start Time1
Start Time2
Start Time3
Start Time4
Report Contents
Figure 5-5 Message report menu
4. Press [Enter] to open the window for PIN code entry.
5. Key in the PIN code.
PIN code (max. 8 digits) should be agreed upon with your recipi-
ent beforehand.
6. Press [Enter] to close the window.
7. Press [
/
].
8. Press [Enter] to open the selection window.
9. Select “ON” or “OFF”.
ON: Message report on
OFF: Message report off
10. Press [Enter] to close the selection window.
11. Press [
/
].
12. Press [Enter] to display the station list.
13. Select a station.