Filter
Top Products
7-3
Selecting EGC Receiving Channel
EGC channel can be selected when the DTE is set to operate as an
EGC-only receiver. This procedure is shown for reference; currently
there is only one EGC channel per NCS.
1. Press [F8] to display the Setup menu.
2. Press [9] to display the Configuration menu.
3. Press [3]. The EGC channel which the EGC receiver is currently
tuned to appears on the display in reverse indication.
File Edit Transmit EGC Reports logs Options Setup Position StopAlarm
Date
Time
Position
Waypoint
Course
Speed
Current NCS
Current Channel
Current TDM
MES Status
GPS Status
DCE Memory
97-08-21
06:12 (UTC)
LAT
LON
LAT
LON
DEG
KTS
344 (IOR) LOGIN
NCS CC
NCS CC
Idle
****
32818 Bytes free
BBER
C/N
Send Level
RxIF AGC Level
REF Offset Freq
Synthe 1st -1 Local
1st -2 Local
RX2nd Local
Antenna Power Supply
Water Temperature
Water Current
Direction
Speed
Depth
004
OK ( 39dB)
OK ( 0)
OK (134)
OK ( 0Hz)
OK
OK
OK
OK
DEG
DEG
KTS
SYNC ( NCS )
NCS: IOR LOGOUT
97-08-21 02:00 (UTC)
LAT: 00:00.00N
LON: 000:00.00E
35:00.00N
135:00.00E
Setup
EGC Channel List
11080* 12580* 10840* 11088*
ENT: set ESC: quit
Current State: EGC RECEIVER
DCE Ver **
Configration
Figure 7-6 EGC channel list screen
4. Select desired channel.
5. Press [Enter] to start the tuning.
6. Press [Esc] to close the Update screen.
7. Press [Enter] to select “Yes”.