Filter
Top Products
User Guide for the Kyocera K132 Phone 13
– On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call will be subject to roaming charges.
•Select
Menu → Settings → Sounds →
Roam Ringer → Enabled. You will hear
the ringer.
Setting Call Guard
You can set the phone to warn you before you
answer or place a call while roaming.
•Select
Menu → Settings → Convenience →
Call Guard → Call Prompt.
– The phone now emits a distinctive roam
ring to indicate when you are roaming
during calls.
– To accept or place a call while roaming,
you must press .
Note: Call Prompt is disabled when the phone is
in emergency mode.
Setting digital or analog mode
Depending on services available from your service
provider, you may set the phone to either digital
or analog mode. This is useful if you are in an
area that borders on digital service and the
automatic feature is causing the phone to keep
switching between modes.
1. Select Menu → Settings → Network →
Digital/Analog.
2. Select an option and press .
– Automatic automatically switches the
phone between digital and analog.
–
Digital only sets the phone to work in
digital mode only.
Turning roaming on or off
This setting allows you to control the phone’s
roaming feature by specifying which signals the
phone will accept.
1. Select Menu → Settings → Network →
Roam Option.
2. Select an option and press .
– Automatic (recommended setting) accepts
any system the phone service provides.
–
No roaming prevents you from making
or receiving calls outside of your home
service area.
Note: If your phone has more than one setting for
Automatic, contact you service provider to
determine which one to use.
82-G1710-2EN.book Page 13 Tuesday, October 3, 2006 9:45 AM