Filter
Top Products
User Guide for the Kyocera Slider Jet Phone 1
1 Getting Started
Installing the battery
Your Kyocera phone comes with a removable
lithium ion (LI Ion) battery. Fully charge the
battery before using the phone.
To install the battery:
1. Hold the phone
face down.
2. Slide the tab at the bottom
of the door up and
remove the battery door.
3. Place the battery in the
phone casing with the
metal contacts facing the
right side of the phone.
4. Replace the battery door
by sliding the notches into
the openings near
the top of the phone.
5. Snap the battery door
closed to secure the cover
into place.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the
AC adapter to the jack
on the bottom of the
phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the
upper-right corner of the screen tells you
whether the phone is:
– Charging (the icon is animated)
– Partially charged
– Fully charged
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Note: To remove the battery, make sure the phone
is powered off.
Note: If you are using a 400 mA charger with any
of the following part numbers: CV90-G2968-01;
CV90-G2610-02; or CV90-60859-1, please be
aware that this power unit is intended to be
correctly oriented in a vertical or floor
mount position.
82-N8963-3EN.book Page 1 Thursday, September 21, 2006 9:04 AM