User Guide for the Kyocera K312 Phone v
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Your service provider’s network controls the power
of the RF signal. This power level can range from
0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure
guidelines with safety levels for hand-held wireless
phones. These guidelines are consistent with the
safety standards previously set by both U.S. and
international standards bodies in the
following reports:
• ANSI C95.1 (American National Standards
Institute, 1992)
• NCRP Report 86 (National Council on
Radiation Protection and
Measurements, 1986)
• ICNIRP (International Commission on
Non-Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by
these reports and the FCC guidelines.
E911 mandates
Where service is available, this handset complies
with the Phase I and Phase II E911 Mandates
issued by the FCC.
Battery and charger specifications
Kyocera Wireless Corp.
10300 Campus Point Drive, San Diego, CA 92121
U.S.A.
Visit us at
www.kyocera-wireless.com
Charger Input Output
CV90-G2588-01 100-240VAC 50/60Hz 0.2A 4.2VDC 0.6A
CV90-G2589-01 100-240VAC 50/60Hz 0.3A 4.5VDC 1.2A
Standard Battery:
CV90-P3030-05 3.7V 1000mAh
82-G1859-1EN.book Page v Friday, December 8, 2006 2:39 PM