Filter
Top Products
3-14 NEC MH150/MH160 Wireless Handset Configuration
NEC MH150/MH160 Mobile Handset Administration Guide - Revision 2
01 - North America
02 -
Europe
03 -
Japan
04 -
Singapore
05 -
Korea
06 -
Taiwan
07
- Hong Kong
• 80
2.11 config—Once the regulatory domain is set, the 802.11
Config modes are displayed. Only one may be chosen. 802.11(b
& b/g mixed) is the default. Press NavOK to set the mode. If the
mode has sub-bands, the Subband list will open. If the mode does
not have sub-bands, the Transmit Power list will open.
Use g only if all of your infrastructure devices use only 802.11g. The handsets will
operate up to 54 mb/s in this mode.
Use b & b/g mixed if some of your infrastructure compone
nts only understand
802.11b. The handsets will operate up to 11 mb/s.
Subbands have not been established for the b an
d b/g mixed or the g only mode at
this writing. Provision is made in the software to accommodate these ranges once
established. Newly added subbands may not appear in the above table.
— Subband
Once a mode is set the subband list wi
ll display, if applicable.
Only those ranges which are allowed in the set regulatory
domain and that pertain to the set mode are displayed. Note
that for 802.11a the bands labeled DFS will vary depending on
the set regulatory domain. Multiple subbands may be set.
Navigate to the desired subband and set with NavOK. The
Transmit Power menu will open. Once the Transmit Power
setting is done, you will be returned to the subband list.
To deselect a subband, navigate to it and press NavOK.
Once the subband settings are
as desired, press the Done
softkey to exit to the Network Setup menu.
—Transmit power
For subbands: The Transm
it Power list opens when NavOK
is pressed from the Subband menu. A transmit power setting is
required for each subband. Only one level may be set per
subband. Only those power levels which apply to the regulatory
domain and 802.11 mode are listed. Navigate to the desired
level and press NavOK to set and return to the subband list.
Another subband may be selected which repeats the process.
If the highlighted power transmit l
evel is legal on all of the
subbands for the set mode, an All softkey will appear. Press the
All softkey to apply that level to all subbands and return to the
subband menu where all subbands will now be selected. All
overrides any previously set power transmit levels.
Without subbands:
When the 802.11 mode has no subbands,
the Transmit Power list opens when NavOK is pressed to set
the mode. Only those power levels which apply to the domain
NOTE