Filter
Top Products
Copyright © 2004 Nokia. All rights reserved.
Tools
69
Many service providers will require you to use an IAP for your default access point. Other
service providers allow you to use a WAP access point. Contact your service provider for
more information.
Start to fill in the settings from the top because depending on what data connection you
select (Data bearer) only certain setting fields are available.
• Connection name - Give a descriptive name for the connection.
• Data bearer - The options are GPRS or Data call. Depending on what data connection you
select, only certain setting fields are available. Fill in all fields marked with Must be
defined, or with an asterisk. Other fields can be left empty, unless you have been
instructed otherwise by your service provider.
To be able to use a data connection, the network operator or service provider must support
this feature, and if necessary, activate it for your SIM card.
• Access point name (for packet data only) - The access point name is needed to establish
a connection to the GPRS network. You obtain the access point name from your
network operator or service provider.
• Dial-up number (for Data call only) - The modem telephone number of the access point.
• User name - Write a user name if required by the service provider. The user name may
be needed to make a data connection, and is usually provided by the service provider.
The user name is often case-sensitive.
• Prompt password - If you must key in a new password every time you log onto a server,
or if you do not want to save your password to the phone, choose Yes.
• Password - A password may be needed to make a data connection, and is usually
provided by the service provider. The password is often case-sensitive. When you are
writing the password, the characters you enter are shown briefly and then changed to
asterisks (*). The easiest way to enter numbers is to press and hold the digit you want
to enter, and then continue entering letters.
• Authentication - Normal / Secure.
• Homepage - Depending on what you are setting up, write either:
• the service address, or