Filter
Top Products
Calling Features 43
Select
Settings
>
Regular Call
>
Recall time
. Press
Select
.
Select the new setting. Press
OK
.
• The setting is saved.
13.4.7.1 Setting the recall pause
time
There are 2 recall pause time options:
Pause 1 and Pause 2.
Press
Menu
.
Select
Settings
>
Regular Call
>
Recall Pause Time
. Press
OK
.
Select the new setting. Press
OK
.
• The setting is saved.
13.4.8 Dial mode
This feature only applies to model(s) that
support both tone and pulse dialing.
Dial mode is the telephone signal used in
your country. Your phone supports tone
(DTMF) and pulse (rotary) dialing. Your
phone shall already be set up for use in
your country. For details, consult your
service provider.
13.4.9 Setting the dial mode
Press
Menu
.
Select
Settings
>
Regular Call
>
Dial
mode
. Press
Select
.
Select the new setting. Press
Select
.
• The setting is saved.
Tip
Temporary Tone
. If your phone is in pulse
dialing, press
* during a call for
temporary tone mode. '*' displays. Digits
entered after '*' are sent out as tone
signals (for this call only).
13.4.10Pause selection
This feature only applies to model(s) with
pause selection support.
A pause is a break you can enter when
making a call. A pause is used for calls
such as PABX and operator services. For
details, consult your service provider.
13.4.10.1 Activating PABX
Press
Menu
.
Select
Settings
>
Regular Call
>
PABX
. Press
OK
.
Select the new setting. Press
OK
.
• The setting is saved.
13.4.11First Ring
This feature only applies to model(s) with
first ring support.
If you have subscribed for Caller ID
service with your service provider, your
phone can suppress the first ring before
the Caller ID. After resetting, your phone
will automatically detect if Caller ID
service is subscribed and start to
suppress the first ring. You can change
this setting to suit your preference.
13.4.12Turning first ring on/off
Press
Menu
.
Select
Settings
>
Regular Call
>
1st
ring
. Press
Select
.
Select the new setting. Press
OK
.
• The setting is saved.
Note
Reset First Ring Status.
To reset the first
ring status, you can reset the system from
the Reset menu. See “Reset the default
settings” on page 50.
2
3
1
2
3
1
2
3
1
2
3
1
2
3