Filter
Top Products
Voice Services
Section 2I. Voice Services 95
To adapt Digit Dial to your voice:
1. Select and press > Tools > Voice Service.
2. Press Settings (right softkey) > Adaptation > Adapt
Voice.
3. Press Start (left softkey) to begin the process. (The
phone displays the first digit sequence.)
4. Wait for the beep, and then repeat the words,
commands, and digits using a normal tone of
voice.
Ⅲ If the recording is acceptable (no mistakes and no
background noises), say
“Yes” or press the left
softkey.
Ⅲ If you need to rerecord the digits to fix any
problems, say
“No” or press the right softkey. (The
phone then prompts you to say the digits again.)
Wait for the beep, and then record the digits
again. (Repeat this step until you are satisfied with
the recording.)
5. After confirming that the recording is acceptable,
repeat the recording process with the next set of
digits.
6. Repeat steps 4 and 5 for an additional nine sets of
digits.
7. When you are finished with a full session, you will
reach a screen that reads, “Adaptation Complete.”
Resetting Digit Dial Adaptation
1. Select and press > Tools > Voice Service.
2. Press Settings (right softkey) > Adaptation >
Reset Voice.
3. Press Yes (left softkey).
Note
It is recommended that you perform the complete
adaptation of Digit Dial at least once to achieve the
maximum benefit of this feature. If a partial adaptation
is performed, you can always return later and resume
the process from the halfway point.
Note
Reset Voice is available only after the phone has
undergone an adaptation session.
Sprint M630.book Page 95 Thursday, January 8, 2009 10:33 AM