Filter
Top Products
Specific Absorption Rates (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF
energy absorbed in the head of a user of a wireless handset.
The SAR value of a phone is the result of an extensive testing,
measuring and calculation process. It does not represent how
much RF the phone emits. All phone models are tested at their
highest value in strict laboratory settings. But when in
operation, the SAR of a phone can be substantially less than the
level reported to the FCC. This is because of a variety of factors
including its proximity to a base station antenna, phone design
and other factors. What is important to remember is that each
phone meets strict federal guidelines. Variations in SARs do not
represent a variation in safety.
All phones must meet the federal standard, which incorporates a
substantial margin of safety. As stated above, variations in SAR
values between different model phones do not mean variations
in safety. SAR values at or below the federal standard of 1.6 W/kg
are considered safe for use by the public.
The highest reported SAR values of the SCP-8100 are:
AMPS mode (Part 22) - Head: 1.42W/kg; Body-worn: 0.79W/kg
CDMA mode (Part 22) - Head: 1.37W/kg; Body-worn: 0.76W/kg
PCS CDMA mode (Part 24) - Head: 1.34W/kg; Body-worn: 1.33W/kg
FCC Radiofrequency Emission
This phone meets the FCC Radiofrequency Emission Guidelines.
FCC ID number: AEZSCP-81H. More information on the phone’s
SAR can be found from the following FCC Website:
http://www.fcc.gov/oet/fccid.
Section 4: Safety Guidelines
4A: Safety 191
Cautions
Any changes or modifications to your phone not expressly
approved in this document could void your warranty for this
equipment, and void your authority to operate this equipment.
Only use approved batteries,antennas and chargers. The use of
any unauthorized accessories may be dangerous and void the
phone warranty if said accessories cause damage or a defect to
the phone.
Although your phone is quite sturdy, it is a complex piece of
equipment and can be broken. Avoid dropping, hitting, bending
or sitting on it.
Body-Worn Operation
To maintain compliance with FCC RF exposure requirements,
Body-worn operations are restricted to belt-clips, holsters or
similar accessories that have no metallic component in the
assembly and that provide at least 0.7 inch (1.8 cm) separation
between the device, including its antenna whether extended or
retracted, and the user’s body. Use of non-authorized
accessories may violate FCC RF exposure requirements.
For more information about RF exposure, please visit the
FCC Website at
www.fcc.gov.
Section 4: Safety Guidelines
190 4A: Safety