6-10 Neuron Exporter Errors (NEX)
NEX# Description
75
The <transceiver_name> transceiver supports a maximum
clock rate of <clock_rate> MHz[NEX#75]
The chosen transceiver requires the Neuron Chip or Smart
Transceiver to operate at a certain maximum clock rate; please
consult your transceiver or Smart Transceiver databook for details.
76
The <neuron_model> Neuron model requires a minimum
clock rate of <clock_rate> MHz[NEX#76]
The chosen Neuron or Smart Transceiver model cannot operate at
the selected clock rate; instead the minimum clock rate indicated
in the message is required.
77
The <neuron_model> Neuron model supports a maximum
clock rate of <clock_rate> MHz[NEX#77]
The chosen Neuron or Smart Transceiver model cannot operate at
the selected clock rate; the maximum clock rate is indicated in the
message.
78
Transceiver doesn't support attenuation
measurements[NEX#78}
Some powerline transceivers support an –attenuation command.
This error is returned when this command is invoked on a
transceiver that does not support it.
4001
Inserting XIF appendix <filename> might have caused an
unwanted duplication of records. Make sure to verify the
XIF file for correctness [NEX#4001]
Multiple XIF appendix files might have caused duplication of
template and value file records. More than one of the following
files contributed to the resulting XIF template and value file
records: .BF2, .XF2, and a possible explicit XIF extension file (--
xifappendix command). Make sure to verify the resulting XIF file,
and remove explicit or implicit XIF appendix files if no longer
needed.
4002
Applicationless state disables some Reboot Options
[NEX#4002]
A device has been exported as application-less. Some of the reboot
options requested are meaningless for this configuration, and will
be ignored.
4003
Specified Reboot Options will prevent network loading
[NEX#4003]
The specified reboot options prevent loading of the application
image over the network.
4004
Old-style dependency file <filename>. Use .nxdep instead
[NEX#4004]
Old-style dependency file was specified. This file format is obsolete
and should not be used any longer. Use --nxdep.
