EPSON Imaging Technology Center Page: 30
Revision: 1 10/6/00
6.10 Set unit “ESC (U nL nH m”
Format:
ASCII ESC ( U nL nH m
Hex 1B 28 55 nL nH m
Decimal 27 40 85 nL nH m
Range of Values for Parameters:
nL=01H, nH=00H
m=05H, 0AH, 14H, 1EH, 28H, 32H, 3CH (units 1/3600 inch)
(=5, 10, 20, 30, 40, 50, 60)
Function:
1) Set the following standard units in units of 1/3600 inch:
Relative horizontal position setting units
Absolute horizontal position setting units
Relative vertical position setting units
Absolute vertical position setting units
Page management units
2) If nL or nH has a value other than the above, then the following (256 x nH + nL)
bytes of data are received, and this command terminates.
3) If m has a value other than the above, this command is ignored.
Initial State:
Page management units: 1/360 inch
Relative horizontal position setting units: 1/180 inch units
Absolute horizontal position setting units: 1/60 inch units
Relative vertical position setting units: 1/360 inch units
Absolute vertical position setting units: 1/360 inch units
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
The units for the relative horizontal position setting by the ESC \ command are set.
The units for the absolute horizontal position setting by the ESC $ command are set.
The units for the relative vertical position setting by the ESC (v command are set.
The units for the absolute vertical position setting by the ESC (V command are set.
The units for the "unit" unit page length specification by the ESC (C command are set.
The units for the page format specification by the ESC (c command are set.
Commands related in the direction of receiving an effect (Operation)
The initial state is returned to by the ESC @ command.
