EPSON Imaging Technology Center Page: 38
Revision: 1 10/6/00
6.17 Select dot size “ESC (e nL nH m d”
Format:
ASCII ESC ( e nL nH m d
Hex 1B 28 65 nL nH m d
Decimal 27 40 101 nL nH m d
Range of Values for Parameters:
nL=02H, nH=00H
m=00H, d=00H, 01H, 02H, 03H, 04H, 10H
Function:
1) The dot size is set according to the value of d.
2) The parameter has the following meaning:
d=00H: default
for a 360 dpi raster, Normal x3dot
………………for a 720 dpi raster, Normal x1,2 dot
3) The defaults are specific to each model of printer.
4) Dot control is valid irrespective of printing mode and printing density.
5) If the dot size is changed part way through a page, the results are unpredictable.
6) If n has any value other than the above, this command is ignored.
Initial State: Default
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
The default is set by the ESC @ command.
The default is set by the ESC (G command.
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
None
