EPSON Imaging Technology Center Page: 47
Revision: 1 10/6/00
6.23 Set paper dimension “ESC (S nL nH w1 w2 w3 w4 l1 l2 l3 l4”
Format:
ASCII ESC ( S nL nH w1 w2 w3 w4 11 12 13 14
Hex 1B 28 53 nL nH w1 w2 w3 w4 11 12 13 14
Decimal 27 40 83 nL nH w1 w2 w3 w4 11 12 13 14
Range of Values for Parameters:
nL=04H, nH=00H
0 <= ( w4*1000000H + w3*10000H + w2*100H + w1 )*1440/(defined unit) <= 7FFFFFFFH
0 <= ( l4*1000000H + l3*10000H + l2*100H + l1 )*1440/(defined unit) <= 7FFFFFFFH
Function:
1) Set paper length ( from top-edge to bottom-edge ) and paper width ( from left-
edge to right-edge ) in the defined unit.
2) This command is used to expand the bottom-margin ( 3mm) of printer.
3) Paper length and width is defined by following formula:
physical paper length = ( l4*1000000H + l3*10000H + l2*100H + l1 ) * ( defined unit )
physical paper width = ( w4*1000000H + w3*10000H + w2*100H + w1 ) * ( defined unit )
4) This command can be used only during graphics mode, entered by sending the
ESC (G command.
5) This command is effective when defined paper length is the same as physical
paper length measured by the printer.
6) The image from a remainder page manager is deleted from the location of a form
piece, in the case that it is shorter than it is long the form that was designated with
this command although it is long a physics form.
7) The paper width is ignored in this printer.
Initial State: -
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
The page control setting unit is set by the ESC (U command.
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
The initial state is returned to by the ESC @ command.
The initial state is returned to by the ESC(G command.
