EPSON Imaging Technology Center Page: 72
Revision: 1 10/6/00
6.43 Select Paper Feed Sequence "EX" 03H 00H 00H m1 m2
Format:
ASCII E X 03H 00H 00H m1 m2
Hex 45 58 03 00 00 m1 m2
Decimal 69 88 3 0 0 m1 m2
Parameters:
* Each of the parameters m1 and m2 is a one byte binary format parameter, and these select
the mechanical sequence as follows:
m1 m2 Mechanical
sequence
Selection
00H 00H Default
00H 01H Paper feed Plain paper
00H 02H sequence Postcards
00H 03H Film paper
00H 04H Envelopes
00H 05H Plain Paper( Load Quickly)
00H 06H Back light film
00H 07H Mat paper
00H 08H Photo paper
01H 00H Platen gap Default ( t=0.1 )
01H 01H Gap1 ( t=0.2 )
01H 02H Gap2 ( t=0.3 )
02H 00H Paper loading
speed
Default ( Normal )
02H 01H Speed1 ( Fast )
02H 02H Speed2 ( Slow )
03H to
FFH
- Reserved -
* With the EPSON Stylus Photo 870, the paper feed sequence shown in Section 2.3, "Paper
Feed Mode", according to the paper size and type, must be selected.
[Function]
* Changes the mechanical sequence for the default environment to the value specified by
m1 and m2.
* If the parameter is out of range (03H - FFH), this command is ignored, and the previous
setting is maintained.
* This command is only valid in remote mode.
