EPSON Imaging Technology Center Page: 32
Revision: 1 10/6/00
6.12 Set absolute vertical print position “ESC (V nL nH mL mH”
Format:
ASCII ESC ( V nL nH mL mH
Hex 1B 28 32 nL nH mL mH
Decimal 27 40 86 nL nH mL mH
Range of Values for Parameters:
nL=02H, nH=00H
(Vertical position set) = (mL + mH x 256) x (units set)
Function:
1) The printing position in the Y direction is set to a position spaced in the positive
direction by (256 x mH + mL) x (the set absolute vertical position unit) inches from the
origin upon the Y axis of the position management coordinate system.
2) If the printing position in the Y direction has been set by this command to a non-
printable region, then the paper is ejected, the position management coordinate system is
set to the next page, and the printing position in the Y direction is reset to the origin upon
the Y axis of the new position management coordinate system.
3) Setting in the negative direction is ignored.
Initial State: -
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
The absolute vertical position unit are set by the ESC( U commands.
The range of impossible printing are set by the ESC( c, ESC N, ESC O commands.
The relative vertical position setting units, the non-printable region, and the printing
position in the Y direction are reset to their initial states by the ESC @ and ESC (G
commands.
