EPSON Imaging Technology Center Page: 31
Revision: 1 10/6/00
6.11 Set unit(extended) “ESC (U nL nH P V H mL mH”
Format:
ASCII ESC ( U nH P V H mL mH
Hex 1B 28 55 nH P V H mL mH
Decimal 27 40 85 nH P V H mL mH
Range of Values for Parameters:
nL=05H, nH=00H
P=( mH*256 + mL ) = 90, 120, 180, 360, 720, 1440
V=( mH*256 + mL ) = 90, 120, 180, 360, 720, 1440
H=( mH*256 + mL ) = 90, 120, 180, 360, 720, 1440
Function:
1) Set the following standard units in units of b/(mH*256+mL) inch:
The H of parameter is horizontal position setting units
The V of parameter is vertical position setting units
The P of parameter is page management units
2) This Command is effective only at the time of the graphic mode.
Initial State:
Page management units: 1/360 inch
Relative horizontal position setting units: 1/180 inch units
Absolute horizontal position setting units: 1/60 inch units
Relative vertical position setting units: 1/360 inch units
Absolute vertical position setting units: 1/360 inch units
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
The units for the relative horizontal position setting by the ESC \,ESC( / command are
set.
The units for the absolute horizontal position setting by the ESC $,ESC( $ command
are set.
The units for the relative vertical position setting by the ESC (v command are set.
The units for the absolute vertical position setting by the ESC (V command are set.
The units for the "unit" unit page length specification by the ESC (C command are set.
The units for the page format specification by the ESC (c command are set.
The units for the paper dimension specification by the ESC (S command are set.
Commands related in the direction of receiving an effect (Operation)
The initial state is returned to by the ESC @ command.
