MMB Web-UI (Web User Interface) Operations
On/ Off of the Location LED can be controlled by clicking [On], [Off] buttons.
Reset MMB Resets the MMB if this check box is checked.
When this check box is checked, [Switch Over to MMB] mentioned below cannot
be set.
Switch Over to MMB Switches the Active/Standby of the MMB if this check box is checked.
When this check box is checked, [Reset MMB] mentioned above cannot be set.
Remarks
This check box is displayed only, when two MMBs are mounted.
Enable/Disable MMB Controls Enable/ Disable of the MMB.
Because this item is a facility used for testing, it is not possible to usually set it.
Displays the Voltage sensor type.
P3.3VL
P1.5VL
P1.5VL_CPLD
P1.2VL
P1.0VL
Displays the current power voltage.
(Low/High)
Lower and upper limits of the warning-level voltage.
Displays “ – ”, when the threshold is not set.
Displays the power voltage in the last two decimal places.
(Low/High)
Lower and upper limits of the critical-level voltage.
Displays “ – ”, when the threshold is not set.
Displays the power voltage in the last two decimal places.
TABLE 1.54 [MMB#x] Window button
Turns on the Location LED when the [On] button is clicked.
Turns off the Location LED when the [Off] button is clicked
Click the [Apply] button to set the specified control information.
Click the [Cancel] button to restore the original information and not set the specified information.
(1) Menu Operation
[System] – [MMB] – [MMB#x]
(2) Window Operations
Confirmation dialogue box is displayed. Specify the information which shows the change in MMB
status, click the [Apply] button. Sets the information which shows the change in MMB status.
[Message]
This section describes the messages to be displayed on this window.
MMB switch processing has started.
The standby MMB is rebooting now. Please wait several minutes.
Failed to switch over to another MMB.
Failed to change Enable/Disable status of the MMB.
%aa cannot be executed because the system is under maintenance.
The reboot is done. Login after a while.
