A SERVICE OF

logo

-7-
Reset button
Use the button to restore the Router to the factory defaults. With the Router powered on, use a pin to
press and hold the Reset button (about 4~5 seconds). After the SYS LED goes out, release the Reset
button. If the SYS LED is flashing with a high frequency about two or three seconds, it means the Router
is restored successfully.
Wifi button
Press this button to enable or disable WI-FI.
2.3.2 Rear Panel
The rear panel of TL-ER604W is shown as the following figure.
Figure 2-2 Rear Panel
Antenna
The router provides two external detachable antennas for receiving and transmitting the wireless data.
Power
The power socket is where you will connect the power adapter. Please use the power adapter provided
with this TL-ER604W SafeStream
Wireless N Gigabit Broadband VPN Router.
On/Off
Press this button to turn on or turn off the Router.
Note:
Please use only the power cord provided with this Router.