-75-
TL-ER604W supports both RIPv1 version and RIPv2 version, thus you can configure the RIP version
based on the actual need to improve the network performance.
Choose the menu Advanced→Routing→RIP to load the following page.
Figure 3-48 RIP
The following items are displayed on this screen:
General
Interface:
Displays the interfaces which has been physically connected or assigned
static IP.
Status:
Enable or disable RIP protocol.
RIP Version:
Select RIPv1 or RIPv2. RIPv2 supports multicast and broadcast.
Password
Authentication:
If RIPv2 is enabled, set the Password Authentication according to the actual
network situation, and the password should not be more than 15 characters.
All Interfaces:
Here you can operate all the interfaces in bulk. All the interfaces will not apply
RIP if “Enable” option for All Interfaces is selected.
List of RIP
After RIP is enabled, the information of RIP forwarding the packets received by the Router will be
displayed in the list.
The first entry in Figure 3-48 indicates: when receivi
ng packets with destination IP is 116.10.20.28, the
Router will select WAN1 which is in the same network with the destination IP as next hop and forward
