TP-Link TL-ER604W Manual

A SERVICE OF

next previous

-58-

The first entry in Figure 3-35 indicates that: This is a Multi-Nets NAT entry named tplink1. The subnet

under the LAN port of the Router is 192.168.2.0/24 and this entry is activated. After the corresponding

Static Route entry is set, the hosts within this subnet can access the Internet through the Router via

NAT.

Note:

● Multi-Nets NAT entry takes effect only when cooperating with the corresponding Static Route

entries.

● For detailed setting of subnet mask, please refer to the Appendix BFAQ

Application Example:

Net

work Requirements

The LAN subnet of TL-ER604W is 192.168.0.0 /24, the subnet of VLAN2 under a three layer switch is

192.168.2.0 /24, while the subnet of VLAN3 is 192.168.3.0 /24. The IP of VLAN for cascading the

switch to the Router is 192.168.0.2. Now the hosts within VLAN2 and VLAN3 desire to access the

Internet.

The network topology is shown as the following:

Configuration procedure

1. Establish the Multi-Nets NAT entries with Subnet/Mask of VLAN2 and VLAN3.