ES-3148 User’s Guide
Chapter 34 Introducing Commands 235
Enter “?” to display a list of commands you can use.
Enter
<command> help to display detailed sub commands and parameters.
Enter
<command> ? to display detailed help information about the sub commands and
parameters.
sysname# ?
baudrate Change baud rate
boot Perform a cold start
cable-diagnostics Execute cable diagnostics
configure Enter configuration mode
copy Backup/Restore system image and configuration
disable Turn off privileged commands
enable Turn on privileged commands
erase Reset system configuration
exit Exit from the EXEC
help Description of the interactive help system
history Show a list of previously run commands
igmp-flush Flush Igmp snooping table
kick Kick a session
logout Exit from the EXEC
mac-flush Flush MAC address table
no Remove configuration
ping Exec ping
reload Perform a warm start
show Show system information
ssh SSH client
traceroute Exec traceroute
write Write running-config
sysname> ping help
Commands available:
ping <ip|host-name>
<
[ in-band|out-of-band|vlan <vlan-id> ]
[ size <0-1472> ]
[ -t ]
>
sysname>
sysname> ping ?
<ip|host-name> destination ip address
help Description of ping help
sysname>
