ES-3148 User’s Guide
260 Chapter 34 Introducing Commands
34.11.6 mvr Commands
The following table lists the mvr commands in configuration mode.
ip address
inband-default
dhcp-bootp
Sets the default in-band interface
to use a static IP address in this
VLAN.
The switch will use the default IP
address of 0.0.0.0 if you do not
configure a static IP address.
13
ip address <ip-
address> <mask>
Deletes the IP address and subnet
mask from this VLAN.
13
ip address
default-gateway
Deletes the default gateway from
this VLAN.
13
exit
Leaves the VLAN configuration
mode.
13
ip address inband-default
dhcp-bootp
Sets the dynamic in-band IP
address.
13
inband-default
dhcp-bootp
release
Releases the dynamic in-band IP
address.
13
inband-default
dhcp-bootp
renew
Updates the dynamic in-band IP
address.
13
inband-default
<ip-address>
<mask>
Sets a static in-band IP address
and subnet mask.
13
<ip-address>
<mask>
manageable
Sets the management IP address
and subnet mask of the switch in
the specified VLAN.
13
<ip-address>
<mask>
Sets the IP address and subnet
mask of the switch in the specified
VLAN.
13
default-gateway
<ip-address>
Sets a default gateway IP address
for this VLAN.
13
Table 88 Command Summary: config-vlan Commands (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 89 mvr Commands
COMMAND DESCRIPTION PRIVILEGE
mvr <1-
4094>
Enters the MVR (Multicast VLAN
Registration) configuration mode.
13
source-port
<port-list>
Sets the source port(s).
An MVR source port can send and
receive multicast traffic in a
multicast VLAN.
13
