Filter
Top Products
DSS Key Functions
4400 and 6400 Series User Guide Page 29
IP Office 3.2 15-601074 Issue 11a (30th June 2006)
Admin Functions
The following can be programmed against a DSS key via the Admin function (see Programming
Functions Against DSS Keys).
Acct
Make a call using an account code or enter an account code during a call. This function can be
programmed with or without data.
Note
• Any account code entered must match a valid code stored on the phone system. If a matching
code does not exist, RENTER ACCOUNT displays when the DSS key is used.
If programmed without an account code, you can enter the code to use after pressing the DSS key.
AD
Dial a stored number. This function requires entry of a number to dial when programmed. The number
does not have to be a complete number, after pressing the DSS key you can dial additional digits to
complete dialling.
Admin
Allows the programming of the functions in this section against other DSS keys. This function can be
programmed with or without data.
If programmed without data see Programming Functions Against DSS Keys.
If programmed with a value of 1, see Storing User, Park Slot and Queue Numbers.
Apear
Set a DSS key to act as an additional call appearance key. If you have call waiting enabled or are using
call coverage you can handle multiple calls and hold and switch between calls using call appearance
keys. This function does not require any data entered when programmed.
AutoCB
Sets a callback when free on a called busy extension and a callback when next used on a called but
unanswered extension. This function does not require any data entered when programmed. When a
callback is set the appropriate DSS key lamp is lit. The DSS key can be pressed again to cancel the
callback.