Filter
Top Products
DSS Key Functions
4400 and 6400 Series User Guide Page 33
IP Office 3.2 15-601074 Issue 11a (30th June 2006)
Programming Using The ProgA Menu
The following functions provide both number storage plus additional functions and DSS key lamp usage.
To store user, park slot and queue numbers under a DSS key:.
1. Press Menu
twice.
2. Press
Next and then press ProgA.
3. Press
Next and then press DSS.
The options shown are Park, User, Group and Dial.
• Park:
Monitor a call park slot by entering the slot number (the extension number
followed by a single digit). When a call is parked in that slot the DSS key flashes. If
you press the key you have options to Drop or Answr the call.
• User:
Monitor another extension. If the extension is ringing the lamp flashes and when
you press the DSS key you can see details of the caller and have a DPkUp option
to answer the call yourself. When the lamp is on the extension is busy and
pressing the DSS key displays information about any call in progress.
• Group:
Monitor the status of a hunt group queue. Flashes green if a call is incoming to the
group. Flashes red if the group has queued calls. To show call information, press
Group. To pickup a call, press Group again.
• Dial:
This is similar to storing a general number but the DSS lamp remains lit until the
call is disconnected.
• Flash:
Send a hook flash signal to the current connected line.
4. Enter the number to store under the key (the park slot, user, group or dial number). Use the left-
hand display key to backspace.
5. Press the DSS key under which you want to store the function.
If the DSS key is already set you will see options to Replace, Keep or Delete the existing
function. Press the option required.
6. When BUTTON PROGRAMMED is shown, press Cont.
7. Press
Exit.