Filter
Top Products
9. Software updating
13.Enter the serial number of the Base Unit and press Enter.
Image 9-17
You can find this number on the label at the bottom of the unit. Format is a 10-digit number.
Reflashing starts.
Image 9-18
When finished successfully, a message appears and the unit will shut down. The complete process can take several minutes.
14.Unplug the software flash stick from the Base Unit and start up the unit by pressing the Standby button at the front of the unit.
After refla shing the Base Unit, verify online whether the latest version of the Base Unit software is installed. If
not, update the Base Unit software via the web in terface or via a USB stick. Refer to "Accessing the ClickShare
Web Interface", p age 51 and "Retrieving software versions", page 85.
9.4 Buttons software update
To update the s oftware of a Button
1. Insert the Button into the USB port of the Base Unit you are using.
92 R5900006 CLICKSHARE 04/12/2013