Filter
Top Products
7. Preparing the buttons
Both the LEDs of the Button and the LEDs of the Base Unit are blinking white. This means pairing is in progress.
The Base Unit automatically checks whether the software of the Button is up to date. If not, the Base Unit updates the Button
software. This may take more time.
During the pairing and update process, a message is displayed on the screen: “Pairing and updating Button. B usy pairing and
updating”
Image 7-2
Pairing message
The result of the pairing process can be as follows:
- When the LEDs become static white, the Button is paired to the Base Unit, but no software update was needed. You can
unplug the Button from the Base Unit.
- When the LEDs become static red, the Button is paired to the Base Unit and the software update has finished. You can unplug
the Button from the Base Unit.
Image 7-3
Pairing finished
2. Unplug the Button from the Base Unit.
Image 7-4
Unplug Button from Base Unit
The Button is now ready for use.
7.2 Pre-install of the Launcher service
Launcher service pre-install
The ClickShare Launcher service can be pre-installed on your laptop or on company level. How this is done depends on your IT
infrastructure.
When the Launcher service is pre-installed, a launcher application runs in the background. When you plug the Button in your laptop,
the ClickShare application will be run from the Button automatically. There is no need to run the file from the Button.
The pre-installer can be downloaded from the Base Unit’s web interface and the Barco website.
50
R5900006 CLICKSHARE 04/12/2013