Filter
Top Products
5. Installing ClickShare
5.3 Wall mounting
About wall mounting
Use the mounting brackets, inserted in the ClickShare box, to mount the Base unit on the wall.
The total weight of the Base Unit — including the mounting brackets — is 2,9 kg.
Necessary tools
• a drill (type of drill depends on the type of wall)
• Torx T10 screwdriver
• Additional screwdriver that matches the mounting screws (mounting screws not delivered)
Necessary parts
• 2 mounting screws
• 2 plugs
• Mounting brackets (included in the ClickShare box)
How to install
1. Drill two holes in the wall, at a distance of 173 mm (6.81 inch) from each other on a horizontal line.
2. Insert a plug in each hole (if needed, depends on the wall type) and drive in the 2 screws. Make sure not to drive in the screws
fully so that the bracket can be hooked on the screws.
Note: Mounting screws and plugs are not included in the ClickShare box . The type of screws and plugs depend on the type
of wall (stone, wood, plasterboard, ...) you are mounting the Base Unit to. Make s ure the head of the screw is not larger
than the hole in the bracket.
3. Install the brackets on the Base Unit as shown on image 5-1. Use the mechanical fixation
points at the bottom of the Base Unit.
Note: Use the pre-mounted Pan Head T10 M3 screws (refer to image 5 -4) to mount the brackets. Rem ove them from the Bas e
Unit and reuse them to fixatethebracketstotheBaseUnit.
24
R5900006 CLICKSHARE 04/12/2013