Filter
Top Products
36 Network
Auto answer
With a headset or hands-free kit attached to
your phone, you can set the phone to
answer automatically.
Select
Menu > Settings > Accessories >
Auto-Answer > After 5 seconds. The phone
automatically answers after 5 seconds.
Com port speed
The Com Port Speed sets the data rate at which
your phone connects to a laptop or PC. Select
Menu > Settings > Accessories >
Com Port Speed and a speed.
There may be a higher charge for making calls
using high-speed data in areas where 1X service
is available. Check with your service provider
for details.
TTY device
You can connect the phone to a teletype (TTY)
device for the hearing impaired.
Note: Enable TTY only when using the phone with
a TTY device.
1. Connect the TTY device to the phone.
2. Enter
##889 with your keypad and select
TTY or select Menu > Settings >
Accessories > TTY Device.
3. At the notification, select OK.
4. Select TTY On to connect or TTY Off to
not connect.
Hearing aid
Enable your phone to operate with a T-coil
Hearing Aid device. Select
Menu > Settings >
Accessories > Hearing Aid > OK > Enabled.
Note: Enable Hearing Aid only when using your
phone with a T-coil Hearing Aid device.
Network
Data calls
Your phone may be able to receive certain data,
depending on the system sending the information.
You cannot receive voice calls while the phone is
in data mode.
To receive data, you must connect the phone to a
laptop or PC and switch the phone from voice
mode to data mode.
Note: To purchase a cable, visit
www.kyocera-wireless.com/store.
To enable data mode, select Menu > Settings >
Network > Data Calls and of the following:
•
Voice Only turns data mode off.
•
Data, next call sets the phone to data mode
for the next incoming call or the next ten
minutes.
• Data, until off sets the phone to data mode
until the phone is turned off.
82-K6572-1EN.book Page 36 Sunday, June 15, 2008 9:47 PM