LG Electronics MMBB0332901 Cell Phone User Manual


 
Getting Started with Your Phone
26
How to Install Your microSD™ Card
1. Locate the microSD™ slot on the right
side of the phone and gently uncover
the slot opening (the microSD™ slot
cover stays attached to the phone so
you don't lose it).
2. Insert the microSD™ card (purchased
separately) with the logos facing up
until it clicks into the slot. If you insert
the card in the wrong direction, it may
damage your phone or your card.
How to Remove Your microSD™ Card
1. Gently push in to release the exposed edge of the microSD™ card to eject it.
2. Remove the microSD™ card from the slot and replace the cover.
NOTE
• Do not attempt to remove the microSD™ card while reading or writing to the card.
• Users wishing to transfer or download music onto a MicroSD™ card inserted into this phone
(through either MTP Sync or Over the Air) should format the MicroSD™ card on this handset
before using it through (Menu -> Settings & Tools -> Memory -> Card Memory -> Options ->
Format). Warning: Formatting the MicroSD™ card will erase all contents on the card. In the event
the MicroSD™ card is used on this phone without first formatting it, the phone will display “License
acquisition failed” during OTAdownloading or MTPSync. Song files downloaded or otherwise
purchased from third party providers and stored on a MicroSD™ card inserted into this device may
be protected or encrypted by such provider and cannot be played on this device.
Charging with USB
You can use your computer to charge your phone. To be able to charge with
the USB cable, you need to have the necessary USB drivers installed on your
PC first. Connect one end of the USB cable to the charging accessory port on
your phone and the other end to a highpower USB port on your PC
(commonly located on the front panel of the computer).
NOTE
Low-powered USB ports are not supported, such as the USB port on your keyboard or bus-
powered USB hub. LG USB Driver is downloadable from the following site:
http://www.lgmobilephones.com > Click SUPPORT> Select a Carrier(Verizon) > Select a
Model > Click USB Cable Driver to download.