Filter
Top Products
Authentication — To always send your
password encrypted, select Secure. To
send your password encrypted when
possible, select Normal.
Homepage — Depending on the access
point you are setting up, enter the web
address or the address of the multimedia
message center.
Use access point — Set the device to
connect to the destination using this
access point after confirmation or
automatically.
Modify advanced GPRS access point
settings
Select Options > Advanced settings.
Select from the following:
Network type — Select the internet
protocol type to transfer data to and from
your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter
the IP address of your device.
DNS addresses — Enter the IP addresses
of the primary and secondary DNS servers,
if required by your service provider. To
obtain these addresses, contact your
internet service provider.
Proxy server address — Enter the
address of the proxy server.
Proxy port number — Enter the port
number of the proxy server.
Wi-Fi internet access points
Select Menu > Settings and
Connectivity > Destinations > Access
point, and follow the instructions.
To edit a wireless LAN (WLAN) access
point, open one of the access point
groups, and select an access point marked
with
.
Follow the instructions from your Wi-Fi
service provider.
Select from the following:
Wi-Fi network name — Select Enter
manually or Search for networks. If you
select an existing network, WLAN network
mode and WLAN security mode are
determined by the settings of its access
point device.
Network status — Define whether the
network name is displayed.
Wi-Fi network mode — Select Ad-hoc
to create an ad hoc network and to allow
devices to send and receive data directly;
a WLAN access point device is not needed.
In an ad hoc network, all devices must use
the same WLAN network name.
Wi-Fi security mode — Select the
encryption used: WEP, 802.1x, orWPA/
WPA2 (802.1x and WPA/WPA2 are not
available for ad hoc networks). If you
select Open network, no encryption is
used. The WEP, 802.1x, and WPA functions
can be used only if the network supports
them.
Homepage — Enter the web address of
the starting page.
Use access point — Set the device to
create a connection using this access point
automatically or after confirmation.
Available options may vary.
View your active data connections
Select Menu > Settings and
Connectivity > Connection mgr..
In the active data connections view, you
can see your data connections:
data calls
packet data connections
WLAN connections
© 2010 Nokia. All rights reserved.48