Filter
Top Products
16 Copyright © 2004 Nokia
1 Connect the charger to an ac
wall outlet.
2 Connect the lead from the
charger to the bottom of your
phone.
If the phone is switched on, the
word Charging appears briefly
and the charging indicator bar
starts scrolling. If the battery is completely empty, it may take a few
minutes before the charging indicator appears on the display or
before any calls can be made.
3 When the battery is fully charged, the charging indicator bar stops
scrolling. Disconnect the charger from the ac wall outlet and the
phone.
You can use the phone while the charger is connected.
The charging time depends on the charger and the battery used. Charging
the BLC-2 battery, when the phone is in standby mode, takes about two
hours when using the ACP-12 charger. If Not charging is displayed, wait
for a while, disconnect the charger, plug it in again and retry. If charging
still fails, contact your dealer.
• SWITCHING THE PHONE ON AND OFF
Warning: Do not switch the phone on when wireless phone use is
prohibited or when it may cause interference or danger.
Press and hold the power key .
• If the phone asks for a code (PIN, UPIN, or
security code), key in the code and press OK.
See Access codes.
• If the phone displays Insert SIM card even
though the SIM card is properly inserted, or
SIM card not supported, contact your service
provider. Your phone does not support 5-V SIM
cards.