Filter
Top Products
26
EN
Un-registering a handset
A handset can un-register another handset registered to the same base. It cannot un-register itself.
1. Press .
2. Select ADVANCED SET and press OK.
3. Select DELETE HS and press OK.
4. Select the handset you would like to un-register and press OK.
5. Enter the Base PIN (by default 0000) and press OK to confirm.
Changing the Base PIN
A PIN (personal identification number) code is required to access the registration, delete handset, and reset
mode.
The factory preset code is “0000”. You can change it to a unique code of your own. A PIN code can be up to
8 digits long.
1. Press .
2. Select ADVANCED SET and press OK.
3. Select CHANGE PIN and press OK.
4. Enter the current Base PIN and press OK.
5. Enter the new Base PIN and press OK.
6. Repeat the new Base PIN and press OK to confirm.
Resetting
You can reset the display, sounds, and other settings of your phone. Refer to the section “Default settings”,
page 35.
1. Press .
2. Select ADVANCED SET and press OK.
3. Select RESET and press OK.
4. Enter the Base PIN and press OK to confirm.
Selecting country*
*country dependent
The correct country setting properly configures your phone to the correct network and language settings of
the country that you are currently in.
1. Press .
2. Select ADVANCED SET and press OK.
3. Select COUNTRY and press OK.
4. Select the desired country and press OK to confirm.
Note : If you have your handset serviced, please make sure it is unregistered from the base station
before taking it back to the repair centre. At least one handset must stay registered on the base.
Note : You will hear a reject tone if the new PIN is not repeated correctly. Follow steps 3 to 7 and try
again.
Warning: Please note that after a reset all saved messages on your answer machine and all your
personal settings will be deleted, however your phonebook and call log entries remain unchanged.
Advanced features