Filter
Top Products
End-of-Call Options
To display the following options, press within 10 seconds after
disconnecting a call.
To select an option, highlight it and press .
ᮣ
Call Again to dial the phone number.
ᮣ
Call:Speaker On to dial the phone number in speakerphone mode.
ᮣ
Save Phone# to save the phone number in your Contacts list. Go to
Phone Book appears when the number is already in your Contacts
list. (See “Saving a Phone Number” on this page.)
Note:The End-of-Call options are not displayed for calls identified as
No ID or Restricted.
Saving a Phone Number
Your PCS Phone can store a total of 500 phone numbers in 300
Contacts entries. Each entry can store up to seven phone numbers
and the entry’s name can contain 16 characters. Your phone
automatically sorts the Contacts entries alphabetically.
To save a number from standby mode:
1. Enter a phone number.
2. Press .
3. Highlight Save Phone# and press .
4. Select a label by highlighting Home, Work, Mobile, Pager,Data,
Fax, or No Label and press .
5. Enter a name and press .
If you have already stored entries in the Contacts list, you are
prompted to select the following entry modes:
ⅷ
New Name to enter a name directly.
ⅷ
From Ph. Bookto select a name from the Phone Book.
6. Press Save (left softkey).
After you have saved the number, the new Contacts entry is
displayed. (See “Contacts List Entry Options” on page 86.)
Section 2: Understanding Your PCS Phone
2A:Your PCS Phone – The Basics 23