ES-4024A User’s Guide
204 Chapter 37 Introducing the Commands
37.2.1 Access Priority
• You can only access the CLI with the administrator account (the default password is
1234).
• By default, only one concurrent access to the CLI is allowed via either the console port or
Telnet. Console port access has higher priority.
37.2.2 The Console Port
Connect to the switch’s console port using a terminal emulation software configured to the
following settings:
• VT100 terminal emulation
• 9600 bps
• No parity
• 8 data bits
• 1 stop bit
• No flow control
37.2.2.1 Initial Screen
When you turn on your switch, it performs several internal tests as well as line initialization.
You can view the initialization information using the console port. After the initialization, the
login screen displays (refer to Section 37.3 on page 205).
Figure 128 Initial Console Port Screen
37.2.3 Telnet
Use the following steps to telnet into your switch.
1 Make sure your computer IP address and the switch IP address are on the same subnet. In
Windows, click Start (usually in the bottom left corner), Run and then type
telnet
192.168.1.1
(the default IP address) and click OK.
2 A login screen displays (refer to Section 37.3 on page 205).
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
initialize mgmt, ethernet address: 00:a0:c5:fe:ea:70
initialize switch, ethernet address: 00:a0:c5:fe:ea:71
Initializing switch unit 0...
Initializing switch unit 1...
Press ENTER to continue...
