ES-4024A User’s Guide
234 Chapter 38 Command Examples
Figure 144 CLI: reload config Command Example
Note: When you use the write memory command without specifying a configuration
file index number, the switch saves the changes to the configuration file the
switch is currently using.
38.5.1 Resetting to the Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1 Enter
erase running config to reset the current running configuration.
2 Enter
write memory to save the changes to the configuration file.
The following example resets configuration file to the factory default settings.
Figure 145 CLI: Reset to the Factory Default Example
38.6 no Command Examples
These are the commonly used command examples that belong to the no group of commands.
38.6.1 no mirror-port
Syntax:
no mirror-port
Disables port mirroring on the switch.
An example is shown next.
ras# reload config 2
ras# erase running-config
ras# write memory
