ES-4024A User’s Guide
Chapter 37 Introducing the Commands 225
37.9.5 interface route-domain Commands
The following table lists the interface route-domain commands in configuration mode.
qos priority <0 .. 7>
Sets the quality of service
priority for an interface.
spanning-tree
Enables STP on the port(s).
path-cost <1-
65535>
Sets the STP path cost for the
specified port(s).
priority <0-255>
Sets the priority for the specified
port(s).
speed-duplex <auto|10-half|10-
full|100-half
|100-full|1000-
full>
Sets the duplex mode (half or
full) and speed (10, 100 or
1000 Mbps) of the connection
on the interface. Selecting
auto (auto-negotiation) makes
one port able to negotiate with a
peer automatically to obtain the
connection speed and duplex
mode that both ends support.
spq
Sets the port(s) to use Strict
Priority Queuing.
test
Performs an interface loopback
test.
vlan-trunking
Enables VLAN Trunking on
ports connected to other
switches or routers (but not
ports directly connected to end
users) to allow frames
belonging to unknown VLAN
groups to pass through the
switch.
wfq
Sets the port(s) to use Weighted
Fair Queuing (WFQ).
<wt0> <wt1> <wt2>
<wt3>
Sets the interface to use WFQ.
A weight value of one to eight is
given to each variable from
wt1
to
wt3.
Table 85 interface port-channel Commands (continued)
COMMAND DESCRIPTION
