ES-4024A User’s Guide
Chapter 38 Command Examples 233
38.4 traceroute
Syntax:
traceroute <ip|host-name> <[ttl <1-255>] [wait <1-60>] [queries
<1-10>]>
where
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100.
Figure 142 traceroute Command Example
38.5 Restarting the Switch
There are two ways in which you can set the switch to use a different configuration file: restart
the switch (cold reboot) and restart the system (warm reboot).
Use the
boot command to restart the switch. The following example restarts the switch to use
the second configuration file.
Figure 143 CLI: boot Command Example
Use the reload command to restart the system. The following example restarts the system to
use the second configuration file.
<ip|hostname> =
The IP address or hostname of an Ethernet device.
[ttl <1-255>] =
Specifies the Time To Live (TTL) period.
[wait <1-60>] =
Specifies the time period to wait.
[quesries <1-10>] =
Specifies how many tries the switch performs the traceroute
function.
ras> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:
ras# boot
